Navigate Yoozpaper

Yoozpaper Front Page
The Yoozpaper
Yoozer Profile
Profile
Shared Paper
Shared Paper
Create Newspaper
Create Paper
Create Customized Paper
Custom Paper
Create Album
Create Album
Yoozer Notifications
Notifications
Edit Profile
Edit Profile
Login
Login

 
 
 
Login on Yoozpaper Facebook Login

Jaw crusher crushing cavity design problems

Written by on


Jaw crusher crushing cavity design problems


0 YOOZ this

Jaw crusher crushing cavity consists of moving jaw, jaw plate and two side wall lining. The crushing cavity is the shape of size of feeding mouth, bite Angle, dynamic jaw plate and fixed jaw plate and two lateral wall plate arrangement. And lining board is determined by factors such as the shape of the longitudinal and transverse section.

Crushing cavity of the cavity shape is the direct main economic and technical indicators of impact crusher, such as productivity, energy consumption, product of granularity, grain shape, and the service life of the lining board, etc., thus taking the attention of the scholars at home and abroad to carry on amount of research work. With the continuous development of the crusher, especially in recent years putting forward "more crushing less grinding" increases crushing ratio and improves the quality of products, whether it is design a new crusher or exist old crusher, modification, design the best crushing cavities are very useful.

According to the moving jaw plate trip to calculate each point on the surface of the actual level of rectilinear crushing cavity, and assumes that the moving jaw balance compared to calculate the rectilinear crushing cavity can be seen that the first crushing cavity in the feeding mouth is productivity much, crushing cavity bottom, about a third smaller height in productivity and discharging mouth productivity as both. The reason is that crushing cavity feeding mouth horizontal stroke, greater than the discharging mouth of the horizontal stroke, and in the crushing cavity. About one-third lower height has a minimum level of schedule. Therefore, in order to improve the discharging mouth production crusher and raise productivity, curvilinear crushing cavity can be used in order to get the best crushing cavity shape, variable bite angle of crushing cavity design, and from the discharging mouth to bite angle value Feeding mouth is gradually increasing, but must ensure that the feeding mouth bite angle value is less than the limit angle of autophagy. In addition, in order to make sure the plate to turn around, the crushing cavity will be made from both ends of symmetry.

In short, when designing the crushing cavity jaw crusher, we should strive to meet the requirements of such: increase production, for liner wear rule, try to extend the service life of lining board, reasonably determine the crushing cavity height, reduce machine weight.

jaw crusher:http://www.jawscrusher.org
impact crusher:http://www.impactscrusher.com
raymond mill: http://www.impactscrusher.com/mill-series/Raymond_Mill.asp
ball mill: http://www.impactscrusher.com/mill-series/Ball.asp
sand washing machine:http://www.vipeakpulverizer.com/XSD_Sand_Washing_Machine.asp
powder Grinder:http://www.vipeakpulverizer.com/HGM_Series_Micropowder_Grinder.asp
grinder:http://www.vipeakgrinder.com

Return to Stable development of crusher industry.





Yoozpaper is a social network of online newspapers written by individuals or groups. Yoozpaper takes free articles that members write and formats them as an online newspaper.

Articles Of The Week

Purchase New Furniture The Easy Way By Using These Tips

Important Tips To Purchasing Furniture For Your House

Ladle with refractory materials are used

Refractory materials for glass furnaces

Kiln refractory selection method